IP68
- ZigBee Modem
Geotechnical
Instrumentation
IP68
Rated Enclosure
Corrosion / Immersion Proof Enclosure - Fully encapsulated
ISM 2.4 GHz
operating frequency
XBee-PRO:
63 mW (+18 dBm) power output (up to 1 mile / 1.6 km RF LOS range)
Gold Plated RPSMA
connector,
Industrial temperature rating (-40° C to 85° C)
Approved for use in
the United States, Canada, Australia and Europe
Advanced Power Management - 1/3 power requirements of any similar model
Ideal
for stand-alone applications
Corrosion / Immersion Proof Enclosure -
XBee-
Industrial temperature rating (-
Advanced Power Management -
ZigBee
Modem Application
The ZigBee-
The
ZigBee-24 module operates just like any other ZigBee modem
in that the signal strength is best when units are in line of sight of
each other.
The advantage of the ZigBee-24 over other similar devices is that is provided
as standard in an immersion and corrosion proof enclosure and will
operate even after the device has been immersed in water.
The wide operating temperature range and the fact the unit will return to normal operation after water levels have receded makes it ideal for deployment into drains, tunnels, man holes in fact any there likely to flood.
Cable Free Tilt Sensor
In applications where power is not a problem then it is possible to deploy the ZigBee-24
modem connected directly to the Tilt-30-02-SDI12
tilt sensor in order to provide simple, low cost cable free systems.
This simple approach to cable free systems makes sure they operate
reliably and are easy to maintain.
The advantage of the ZigBee-
The wide operating temperature range and the fact the unit will return to normal operation after water levels have receded makes it ideal for deployment into drains, tunnels, man holes in fact any there likely to flood.
Cable Free Tilt Sensor
In applications where power is not a problem then it is possible to deploy the ZigBee-
Installation
& operations
The
ZigBee-24 modem is connected to the AquaLOG via the 9 pin
modem port. It is powered directly from the AquaLOG and can be
configured for continuous data transmission or, powered off and set to
broadcast data only at a set time to maintain power.
Tilt
Sensor
Maintenance
Due to the method of construction of the ZigBee-24 modem and after the device
has been submerged for any period of time, wash the device under clean
tap water to remove any unwanted material that has collected onto the
terminal port and power supply pins.
The gold plated terminal pins should keep the unit safe from immersion damage.
Due to the method of construction of the ZigBee-
The gold plated terminal pins should keep the unit safe from immersion damage.
