Keynes Controls Product Setup Videos
The following video clips demonstrate how to configure the various Keynes Controls products.
The aim of these small videos is to demonstrate by example how the main features of the hardware is configured especially when using the ‘Terminal Menu Systems’ built into the products.
All of the videos are MP4 format and can be downloaded from the links provided.
The Keynes Controls training
videos only
use the USB-
Most of the Keynes Controls data acquisition system hardware and sensor interfaces are configured using built in menu system. Video shows how to use the AquaLOG terminal port menu system.
The menu system can be accessed using a ‘Terminal Emulator’ program.
Default settings are: Terminal type = VT100
Communications : 9600 B, 8 bit, 1 Stop, N parity
Flow control = Non.
The terminal port settings are the same for all products.
Q-
The following video clip shows
how how to
start up Q-
Further Information
The example shows 2 x AquaDAT
sensor
interface units running on an SDI-
Each AquaDAT has been configured to operate as an 8 channel differential input data acquisition unit.
The number and type of sensor
inputs on
the AquaDAT is a setting on the device itself and is not defined by Q-
USB-
The following video clip shows how to setup a panel meter
to display data from a sensor.
1. Start Q-
2. Set network COM Port
3. Show Variable List
4. Change Sensor Name & Units
5. Select Panel meter -
6. Start Data Acquisition
Further Information
2 x AquaDAT sensor interfaces with SDI12 ID = 5 and ID = 6
connected to a USB-
The USB-
serial port
The AquaDAT sensor interfaces
have
already set to return 8 values each on receipt of send data command. 8
x DE inputs set inside AquaDAT and not by Q-
Configure a AquaLOG data logger
for use
with the Ezi-
Data Table -
Small data table
Width of data table = 40 columns
Circular log for repeat recording
Data update period to Ezi-
Once configured the logger switched to ** CLI ** mode.
Device left ready for communications across GPRS network.