Complete Solution
AquaBat Water Level Recording System
The image below shows
the complete
water level recording system based upon AquaLOG instrumentation. The
complete system is modular in construction and can expanded to use
additional environmental sensors.
The system supports as standard up
to 10 additional sensors such as anemometers, light level, rain sensors
etc.
The AquaLOG instrumentation has
been designed from the start or remote field applications due to its
low power operation and ability to use a range of different power
supply options. The systems can be supplied to run on batteries, solar
panels or mains supply.
The system uses the Keynes Controls
‘PIEZO-RM-SDI12’
range of sensors to measure the water level and the Barom-SDI12
barometer module fto measure local
barometric conditions. A simple calculation in the logger
corrects to the correct barometric level. The logger supports
additional formulae to use local salinity, water temperature and local
gravity for precise level measurements.
Maximum Deployment
Length
=
150 m
Outside Diameter
=
25 mm
Optional SDI-12
barometer module
Barometric correction is carried
out using the optional Barom-SDI12
module. This unit returns the barometric
values in the same engineering units as the water level sensor. A
simple subtraction corrects the water level to the true result.
SDI-12
Liquid Level Sensors
Keynes Controls SDI-12
digital network encapsulated water level sensor.
Part No PIEZO-RM-BAR.
available 1,2,5,10 bar /
10/20/50/100 m
Part Numbers:
PIEZO-1-SDI12
10 m range
PIEZO-2-SDI12
20 m range
PIEZO-5-SDI12
50 m range
PIEZO-10-SDI12
100 m range
The details are
accurate at the
time of publishing. Details can change without notice.